Glue - cement, standard 25 kg BETEK FAYFIKS

Glue - cement, standard 25 kg BETEK FAYFIKS

• Base: cement
• Color: gray (dry powder)
• Density: 1.4 ± 0.1g/cm3
• Drying time: 3 hours
• Weight: 25 kg
• Brand: Betek
• Country of manufacture: Georgia

Cement-based adhesive with increased resistance to vertical slippage, for bonding ceramic tiles.
Application areas: The product is used on interior walls and floors with ceramics, tiles, or similar facing materials, as well as for exterior floor coverings. It is recommended for use on cement-based plaster, concrete screed and concrete surfaces.

Technical characteristics:

Adhesion strength: ≥ 0.5 N/mm2;
Water mixing volume: 5.5 - 6.5 l;
Drying time in a bucket: approximately 3 hours;
Open time: 20 minutes;
Possibility of filling the gaps: at least 48 hours later.  

The above times are calculated based on a temperature of 23 ± 20 C and a humidity of 50 ± 5 %. At higher temperatures, the duration will be reduced, while at lower temperatures the duration will increase.

Application: The surface on which the standard adhesive cement will be applied must be clean, dry and solid. The surface must be sanded free of any coarse debris. Porous and water-absorbing areas must be moistened before application. Resin cement 5.5 – Slowly pour into a bucket filled with 6.5 liters of water and mix with a low-speed mixer until a homogeneous mass is obtained, then pour for 5 minutes and mix again with a mixer for 1 - 2 minutes. The prepared mortar should be applied to the facing material with an appropriate notched trowel. The prepared mortar should be used within a maximum of 20 minutes. The thickness of the prepared mortar is determined by the notched trowel. On facing tiles larger than 20X20 cm, application should be made on both sides (both on the tile and on the surface), and the size of the trowel teeth should also be increased. For good results, trowel crosses and a rubber mallet should be used during application. The ambient temperature should be between +5 + 300 C. Do not use in direct sunlight. A test is recommended to determine the exact consumption.
Storage: Unopened packaging can be stored in a dry and cool place for 1 year.

Risks: Hazard statement: H315: Causes skin irritation; H318: Causes eye damage; H335 may cause respiratory irritation; Safety precautions: P101 If medical advice is needed, have product label at hand; P102: Keep out of reach of children; P103: Read label before use; P261: Avoid breathing dust, fumes, gas, vapors, and spray; P305+P351+P338: If in eyes, rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do, and continue rinsing with water. P321: Dispose of contact lenses (see label); P405: Keep container tightly closed; P501: Dispose of waste and container in accordance with local/regional/national/international regulations.