Frost and moisture resistant glue-cement TA-10

Frost and moisture resistant glue-cement TA-10

• Color: light gray
• Dry powder density: 1.35±0.1 g/cm3
• Water mixing capacity: 5.5-6.5 l
• Chill drying time: about 3 hours
• Duration of open practice: 30 minutes;
• Possibility of filling earnings: 24-48  after hours
• Fire class: A1
• Adhesion strength: ≥0.5 N/mm²

Application: The surface on which TA-10 will be applied must be clean, dry and solid. Bumps on the surface should be scraped off. Porous and absorbent areas should be wetted before use. resin cement 5.5 – Pour 6.5 liters of water into a sieve and mix with a low-speed mixer until a homogeneous mass is obtained, then let it rest for 5 minutes and add 1 – Mix again with a mixer for 2 minutes. The prepared mixture should be applied to the paving material with a suitable toothed trowel. Prepared fermentation should be spent in maximum 20 minutes.

• The thickness of the prepared broth is determined with a toothed spatula. On paving tiles larger than 20x20 cm, two-sided application (both on the tile and on the surface) should be done, and the size of the teeth of the brush should also be increased.
• For best results, dovetails and a rubber mallet should be used when applying.
• The ambient temperature should be between +5 + 30⁰ C.
• It should not be used under direct sunlight.

The above times, 23  ± at a temperature of 2⁰ C and 50  ± It is calculated according to 5% humidity. At higher temperatures, the duration will decrease, and at lower temperatures, the duration will increase.

Expense :

Dimensions of ceramics                                   comb   spending

10 cm X 10 cm                                                                       6X6X6 mm    3 – 4 kg / m2

10 cm X 10 cm - between 20 cm X 20 cm                   8X8X8 mm      4 – 5 kg / m2

20 cm X 20 cm - between 30 cm X 30 cm                   10X10X10 mm      6 – 7 kg / m2 (two-sided application)

Indicated figures are approximate, and testing is recommended to understand the exact cost.

Storage: Unopened packaging can be stored in a dry and cool place for 1 year.

Packaging:

25 kg cardboard bag

Risks: Risk content

H315: Causes skin damage;

H318: Causes damage to eyes;

H335 may cause irritation of the respiratory system; Security measures;

P101 In case of medical emergency, take product label with you;

P280: Use protective gloves and clothing;

P264: Wash protective clothing and gloves thoroughly with suitable liquids after use;

P321: Special use (see label);

P362: Take off spilled clothing and wash before reuse; P332+P313: In case of skin irritation, get medical advice; P302+P352: Wash thoroughly with soap and water; 

P405: Keep sealed;

P501: Dispose of waste and containers in accordance with local/regional/national/international regulations.

It is a resin cement made on the basis of cement, with a high resistance to slippage, which has an extended waiting time in the boiling point.  gives an improved  result when used.  The product complies with TS EN 12004 standard, C1TE class.